If you maintain the mining mchine well, which will prolong the lifetime of those mining machine. So is the high weir type double spiral classifier. But do you know how to maintain the high weir type double spiral calssifier?
Of the correct installation and operation is also very important for the maintenance of high weir type double spiral classifier. The installation programs of high weir type double spiral classifier are in the following：
(1) water tank installed on the basis, according to the drawings for correction Angle; (2) the transmission part and the screw shaft is installed on the tank, and adjust;Lifting mechanism; (3) the two columns (channel steel frame) with bolts, become an organic whole repeatedly with the following column alignment straight after welding; (4) device lifting mechanism, adjust the inspection point switch; (5) level machine parts after all outfit, will sink pad, tighten the anchor bolts, test run, carefully check the lubrication part, after the oil cup filled with lubricant.
2, maintenance and operation of high weir type double spiral classifier are in the following:
(1) the machine operator must know the machine structure and performance;
(2) the machine back to sand production capacity is related to screw revolution.
(3) in the operation to prevent larger material or grinding machine down the steel ball falls to the classifier, in the feed channel should be adapted to install metal mesh;
(4) when to stop working, should choose to stop feeding, cleared the spiral groove in the material, when suddenly stopped working, will spiral rising, in order to avoid silting up.
(5) improve the spiral, the blade has left in the fluid, should immediately stop the spiral ascending, falling spiral blade had been exposed to the surface of the water, just can make the screw rotation, when the screw up to the highest position, ought to use wire rope will spiral hang on, lest because screw load and deformation for a long time.
(6) in a spiral rotation has to normal work, pulp was graded into the sink, under the support and sink groove bottom is not allowed to leave.
(7) the end of the lifting mechanism switch security device, the operator should check the switch Sensitivity, prevent accidents.During the period of employment,
(8) must pay attention to the lubrication parts, filling in time, support with circulating water lubrication.
(9) to ensure the operation of classifier is often good, should have a plan of preventive maintenance.
For more: http://chinaquarry.com.
maintenance and operation of high weir type double spiral classifier: http://www.chinaquarry.com/products_show/pro30.html