I've split my question up into two parts:
Part 1
After investigating my consumer unit (after I first started to wonder about things in part 2 below) I'm confused regarding the AMPS my RCDs are rated to take.
My home (which is a new build from 2010) has the consumer unit split in two, with two RCD units (I think they are) splitting up the trip switches. The split is as follows
Left most trip switches
6A trip - Down stairs lights
20A trip - Kitchen Grid switches for fridge, washing machine, dish washer
32A trip - Ring main wall sockets
32A trip - cooker
90A total - These are connected to an 80A RCD
Right most trip switches
6A trip - Up stairs lights
6A trip - Smoke Alarms (up/down stairs)
16A trip - Central Heating
32A trip - Ring main wall sockets
40A trip - Electric Shower
100A total - These are connected to an 80A RCD
Lastly
100A - Main Switch/Trip for consumer unit
As you can see the RCDs are rated at 80A but the combined amps of the trips going into them both, exceed the rated amperage and not only that the combined amps of all trips/RCDs far exceed that of the main consumer unit trip. What am I missing here, im sure it's right, I just don't understand it.
As I understand things, we're always told to not exceed 13A on a wall socket if we use a strip plug. Hence I'm guessing all plugs connected to either ring main shouldn't exceed 32Amps. Is this correct? It just seems low to me. Run the Kettle-13A, Microwave-13A and TV-10A and I'm above 32A there...I don't get it.
If I apply the same logic to the consumer unit, why is there potential for all trip switches combined to exceed the RCDs they are connected to and further to this the main consumer unit switch? I must be missing something fundamental here and would greatly appreciate some clarity on the matter.
Part 2
I'm sure an explanation of the above will also explain my confusion here to. Basically I confused regarding the max AMPs a UK ring main will accept (given a strip plug shouldn't exceed 13A) and was seeking some advice and information to clear up the confusion.
I'm setting up a new marine aquarium which has a lot of equipment. There are at least 15 plugs going to be used. At minimum thats a potential 45A right there if all plugs were 3A (which they are not, some are 5 &13). If the potential amps is above 32 does this mean I can't connect them to my ring main via multiple strip sockets plugged into several wall sockets. If so then how do I get around this? Install a new Trip switch in the Consumer Unit and run a cable specifically for this project?
People regularly do what I'm doing, use multiple strip sockets plug everything in, everything works and they don't worry. But I'm baffled by it as I'm not sure thats the safest thing to be doing plus have spare Amps for all the other normal house hold electricals. I'm so confused with AMPS because of what people say in overloading those strip sockets, surely the same logic applies to the trip switches themselves?
Thanks.