Resetter Canon ip7240
Resetter Canon ip7240 Resetting the waste ink safeguard on a Canon printer can resolve some mistake codes that show up when turning it on.
Verify the printer is turned off.
Press and hold the Resume catch (triangle inside a circle).
Whilst it is held down, hold down the Power catch. The green drove light ought to go ahead.
Keep the Power catch held down. Discharge the Resume catch and after that press it twice. The light ought to go golden, then green once more.
Discharge the Power catch.
Press the Resume catch four times and after that press the Power catch straight after to affirm the chose activity (Reset Counter Absorber).
Turn off the printer and after that turn it on once more
Link Download
Guidelines for utilization: First the printer must enter administration mode. No different printers ought to be joined with the PC. This is methodology for my MP 540, from the administration manual, the method for your printer may be distinctive:
i. With the machine force turned off, while pressing the Stop catch, press and hold the ON
catch. (Don't discharge the catches).
ii. At the point when the Power LED lights in green, while holding the ON catch, discharge the Stop catch.
(Don't discharge the ON catch.)
iii. While holding the ON catch, press the Stop catch 2 times, and afterward discharge both the ON
also Stop catches. (Each one time the Stop catch is pressed, the Alarm and Power LEDs light
then again, Alarm in orange and Power in green, beginning with Alarm LED.)
iv. At the point when the Power LED lights in green, the machine is prepared for the administration mode operation.
The LCD show now demonstrates two lines of content: 1: Service mode and 2: Idle.
Before beginning the administration apparatus, make beyond any doubt that both tape and back tray contains paper, else administration mode operations may come up short, as you can't anticipate which paper source the printer will utilize.
Presently run the unpacked ServiceTool_V2000.exe record. No establishment fundamental.
You now see this window with two tabs. Click thumbs to broaden
and
I've attempted just the "Test Print" and "EEPROM" catches on the "Primary" tab. You can change a few settings with the system, yet unless totally important don't attempt different operations , particularly on the off chance that you don't have the administration manual. You may erase illumination or change imperative settings. I've committed such errors my self, subsequently this cautioning. Connection here